BCP Crystal Wax

Application Instructions:

• Prepare the surface before waxing by removing previous waxes and sealants. The best way to do this is by light machine polish, an example would be Scholl Concepts S40 with a soft pad. Followed by a thorough wipe down using an alcohol-based panel wipe like isopropanol.
• Take 1-2 swipes from the pot, only use soft foam to apply this wax. Once you have loaded the applicator proceed to press it over a small area of the panel several times, this creates an even application by collecting more wax as you work across the panel. Always ensure an even thin layer is applied, over-application will have negative effects on removal and performance.
• Remove the wax with a short pile towel after 1-5 minutes maximum, this means only 1 panel at a time. It is normal to see a hazy residue after initial removal. Removing this residue is done by using buffing towel, wipe in straight lines to ensure the light residue has been removed.
• After application, allow 3 hours for this wax to bond before wetting the vehicle and do not wash for 7 days after application

Safety information:

Always wear gloves when using this wax, in some confined spaces you may wish to use a mask for application. If drowsiness or headaches start to occur stop using and move to an area of fresh air. If any skin irritation develops stop using, remove clothing which may be contaminated and wash the skin with cold soapy water only, begin to introduce gentle scrubbing unless the skin is broken. If in any doubt seek medical advice.

Storage information:

Always store this wax in a cool area where temperature fluctuations are minimal.